I wanted to get some photos shot to go with thise. I'll try later. It's still hard to do much. My back is better but my foot is stilla problem.
See sample in gallery.
Homemade Bunnies - Stampin' Addicts Gallery
Bunny Box
You can make this from card stock or designer paper.
I used Candy Lane designer paper for my bunny.
Cut card stock or designer paper:
Body piece 2” x 12”
Cut 2 side pieces 2 1/8” x 4 1/8”
One scallop from Big Shot BigZ XL Pennant die
Punch:
4 small ovals from same card stock as body
2 small ovals from white or coordinating designer paper
2 large ovals from same card stock as body
1 scallop or Wide Oval from Whisper White - crimp in both directions or run thru SU small dots texture plate
2 - ½” circles Whisper White
2-¼’ circles Close to Cocoa
1 - ¼” circle Pink Passion
1 Scallop circle punch - Whisper White for tail - crimp in both directions or run thru SU small dots texture plate
Score 2” x 12” strip at 3 ¾” and 5 ¼”
Fold on all score lines
On short side attach Whisper White oval for tummy.
Attach arms to inside of front side of box.
Attach feet so they stick 2/3 beyond fold line.
On 2 side pieces that measure 2 1/8” x 4 1/8”
Score sides ¼” on 2 long sides and one short side
Cut away boxes in corners
Score down center of side piece from top edge to 3 ¼”
Score from each bottom corner to end of line at 3 ¼”
Fold on all score lines
Apply tacky tape to all 3 flaps
Attach bottom edge and then 2 sides press firmly
Fold in center fold in sides.
Once basic box is assembled pinch top together.
Fold long side over top of box.
Fold scallop so it is 2/3 over front of box.
Trim long flap so it ends behind scallop.
Attach scallop to this flap.
Attach small ovals to large ovals for ears.
Attach ears on backside of scallop face.
Note for DSP you will need to punch extra ovals to hide reverse side of DSP.
Attach ¼” Close to Cocoa to ½” circle for eyes. Attach these and Pink nose to face. I used dimensionals for eyes.
Pm me with any questions!
Linear Mode
