Morning and welcome to Monday's 3D Challenge! For the month of December we will be doing challenges from the past! So the first one I decided to do again was the Tea Bag Holder!
1. Cut 1 piece of card stock 3 1/4" x 7"; score at 1 1/2" and 4 1/4".
2. Cut 2 pieces of card stock 2 1/2"x 3". One is for the front and one is for the inside.
3. Cut 2 pieces of card stock 2 1/4" x 2 3/4". One is for the front and one is for the inside.
4. Cut 1 pieces of DSP 2" x 2 1/2".
5. Cut 1 piece of card stock 2" x 2 1/2". This is for the inside so you have a spot to write a message or stamp something.
6. Cut 1 piece of DSP card stock 1" x 3 1/4". Punch it using the Scallop Trim Border Punch. Snail to the pocket part which will be the 1 1/2" part.
7. Cut 1 piece of card stock 3/4" x 3 1/4". Snail to the top side of the pocket part. Run Ribbon around, and secure with glue dots. Then Run Sticky Strip across the top and bottom; close and you've created the pocket for your tea bag.
Video Tutorial~
Rules~ (Please do this so we can find the project.)
1. Use only SU products
2. Put 3D071SUO in your keywords when you up load to the 3-D challenge gallery. Please Post projects in our gallery!
3. Have Fun!!!Please post to this thread when you upload your project so I don't miss it!
Remember you can do this challenge whenever there is no time limit at all!
I can't wait to see what you all come up with! Happy Stamping!!
Posting Permissions
Reply With Quote